View Single Post
Old 06-29-2015, 09:09 AM
ducks's Avatar
ducks ducks is offline
Join Date: Nov 2008
Location: Netherlands
Posts: 1,701
Send a message via MSN to ducks

It's the frictional forces of the mating surfaces that keep the wheel in place. If you have an aluminum spacer with a hub centric lip. Do you really think that little 3mm thick lip will be able to bear the load. It would snap off in an instance. A cast iron hub might take a bit more load but I would not trust my life on it if the ring was the only load bearing part.
Reply With Quote