Making a harness bar

[dawgscj7]

I am going to fab a harness bar, how do you get the interior b pillar covers off as well as cut them without f-ing them up?

Im using 1.75 tube and two 1/4" plates to mount to the pillar for anyone who asking how.

[ScottinBend]

Check out this site and see if they have any instructions available.

http://www.kappasphere.com/newest_stuff/monkeybar.cfm

[dawgscj7]

Im not making a seat mount, mine will mount on the b pillars and will also provide chassis rigidity

[ScottinBend]

Seat mount........? Not sure what you mean by this, but it is a harness bar like you are describing. It has some additional supports (that you really need to consider for your design) but it still has an attachment to the b pillar.

If you think a simple bar going from b pillar to b pillar is going to add any stiffness, you need to rethink your design.

[dawgscj7]

I need post up some rendering so you understand but I just need to know how to get the b pillar covers off thanks

[minimusprime]

some good instructions here. http://tinyurl.com/harnessbarinstructions

[Kappasphere]

Using the factory seat belt mounts like we did wtih the monkeyBAR is the safest way to go because you are using factory-crash-tested locations. I'd be very very careful about just bolting or welding a bar to the b-pillar.