motoring|underground (
-   Accelerating (
-   -   81 mm Big Bore W11 engine. (R52-R53) (

Thumper460 09-05-2020 01:10 PM

81 mm Big Bore W11 engine. (R52-R53)
As we continue having fun with the W11 R53 MCS, We have been approached numerous times on ENGINE BUILDS. So we decided to make a 'big bore' engine. (1.8 Ltr engine)
81 mm bore ( vs the 77 mm stock) forged Pistons, Polished Steel Crankshaft, K1 H-beam rods, Engine block is bored and sleeved with a STEEL Sleeve. Engine is then 'blueprinted' ( clearance/end gaps/Decked ) and assembled. This is the SHORT BLOCK only.

Parts used:

JE Custom Forged Pistons
JE Ring-set and Locks
K1 H-Beam connecting rods
Crankshaft mic'd and polished
Aluminum-silicon Performance Rod and Main Bearings
STEEL Sleeve Then Bored and Clearances set

Give us a PM or check my FB page.

All times are GMT. The time now is 07:48 PM.

Powered by vBulletin® Version 3.8.1
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
2005 motoring|underground, all rights reserved.